Reversing The Door Swing - Atlas NFS 166 Bedienungsanleitung

Reversing the Door Swing
1. Make sure that your freezer is unplugged.
2. Pry the hinge cover up and off, remove the three screws that
secure the upper hinge to the door, then remove the hinge.
3. Remove the freezer compartment door from the cabinet.
4. Remove the screws that secure the lower hinge to the right
side of the cabinet, then remove the hinge.
5. Remove the washer and nut that secure the pin shaft to the
right hole on the lower hinge, then remove the shaft
6. Insert the pin shaft into the left hole on the lower hinge, then
secure the shaft with the washer and nut.
7. Install the lower hinge on the left side of the cabinet.
10. Remove the screw that secures the door stop from the bot-
tom right of the freezer compartment door, then remove the
door stop and install to the bottom left side.
8. Install the freezer compartment door.
9. Move the door bushing from the top right side of the freezer
door to the top left side of the door. And move the left hole cov-
er to the right side.
10. Remove the screw that secures the hinge screw hole cover
from the top left side of the cabinet, remove the cover and se-
cures the cover on the top right side of the cabinet.
11. Secure the upper hinge to the top left side of the cabinet
with the three screws you removed previously. Before you tight-
en the upper hinge screws, make sure that the top of the door is
level with the cabinet and that the rubber gasket makes a good
seal.
20. Install the hinge cover over the hinge on the top left side of
the cabinet.
12. Remove the left hole plugs, screw off the bolts, and remove
the right hole plugs.
13. Install the right hole plugs on the left side of the door, and in-
stall the handle on the right side of the door.
12