Reversing The Door Swing - Atlas KFS 227 Bedienungsanleitung

Reversing the Door Swing

1. Make sure that your refrigerator is unplugged.
2. Pry the hinge cover up and off, remove the three screws that secure the
upper hinge to the door, then remove the hinge.
3. Remove the freezer compartment door from the cabinet.
4. Remove the two screws that secure the center hinge.
5. Remove the freezer compartment door.
6. Remove the screws that secure the lower hinge to the right side of the
cabinet, then remove the hinge.
7. Remove the washer and nut that secure the pin shaft to the right hole on the
lower hinge, then remove the shaft
8. Insert the pin shaft into the left hole on the lower hinge, then secure the shaft
with the washer and nut.
9. Install the lower hinge on the left side of the cabinet.
10. Remove the screw that secures the door stop from the bottom right of the
refrigerator compartment door, then remove the door stop and install to
the bottom left side.
11. Install the refrigerator compartment door.
12. Move the door bushing from the top right side of the freezer door to the
top left side of the door. And move the left hole cover to the right side.
13. Remove the center hinge screw hole plug on the left side of the cabinet,
then install in the screw holes on the right side of the cabinet.
14. Install the center hinge to the left side with the two screws you removed
previously.
15. Remove the screw that secures the door stop from the bottom right of the
freezer compartment door, then remove the door stop and install to the
bottom left side.
16. Install the Freezer compartment door.
17. Move the door bushing from the top right side of the freezer door to the
top left side of the door. And move the left hole cover to the right side.