Reversing The Door - Atlas KFS 315RF Bedienungsanleitung

Certifications
Electrical information
This electrical appliance must be grounded
This product is equipped with a plug, which is suitable for all
houses equipped with sockets meeting the current specifications
If the fitted plug is not suitable for your socket outlets, it should
be cut off and carefully disposed of. To avoid a possible shock
hazard, do not insert the discarded plug into a socket.
This product complies the EEC directives.
Disposal
Old appliances still have some surplus value. An environmentally
friendly approach will ensure that valuable raw materials are re-
cycled.
The refrigerants used in your equipment and insulation materials
require special handling procedures. Make sure there is no pipe
damage on the back of the equipment before handling.
Up-to-date information on the options for disposing of old
equipment and packaging from old equipment can be obtained
from the local municipal office.
Correct Disposal of this product
This marking indicates that this product should not be disposed
with other household wastes throughout the EU. To prevent pos-
sible harm to the environment or human health from uncon-
trolled waste disposal, recycle it responsibly to promote the sus-
tainable reuse of material resources. To return your used device,
please use the return and collection systems or contact the re-
tailer where the product was purchased. They can take this
product for environmental safe recycling.
Reversing the Door
1. Make sure that your refrigerator is unplugged.
2. Pry the hinge cover up and off, remove the three screws that
secure the upper hinge to the door, then remove the hinge.
3. Remove the refrigerator compartment door from the cabinet.
4. Remove the two screws that secure the center hinge.
5. Remove the freezer compartment door.
6. Remove the screws that secure the lower hinge to the right
side of the cabinet, then remove the hinge.
15
7. Remove the washer and nut that secure the pin shaft to the
right hole on the lower hinge, then remove the shaft
8. Insert the pin shaft into the left hole on the lower hinge, then
secure the shaft with the washer and nut.
9. Install the lower hinge on the left side of the cabinet.
10. Remove the screw that secures the door stop from the bot-
tom right of the freezer compartment door, then remove the
door stop and install to the bottom left side.
11. Install the freezer compartment door.
12. Move the door bushing from the top right side of the freezer
door to the top left side of the door. And move the left hole cov-
er to the right side.
13. Remove the center hinge screw hole plug on the left side of
the cabinet, then install in the screw holes on the right side of
the cabinet.
14. Install the center hinge to the left side with the two screws
you removed previously.
15. Get the left door stop from the accessory bag, install it on the
bottom left side of the refrigerator door.