English - Philips Marathon FC9200 Bedienungsanleitung

ENGLISH

6
General description (fig. 1)
A Cover
B On/off button
C Suction power knob
D Cleaning brush
E Motor Protection Filter
F Dust bucket
G Dust bucket release button
H Filter cylinder case
I Filter cylinder
J Hose connector
K Handgrip
L Accessory holder
M Telescopic tube
N Tri-Active nozzle
O Crevice tool
P Small nozzle (specific types only)
Q Small brush
R Super Clean Air Filter or Super Clean Air HEPA Filter
S Filter grille
T Parking slot
U Cord rewind button
Important
Read these instructions for use carefully before using the appliance and save them for future
reference.
Check if the voltage indicated on the appliance corresponds to the local mains voltage before
you connect the appliance.
Do not use the appliance if the plug, the cord or the appliance itself is damaged.
If the mains cord of this appliance is damaged, it must be replaced by Philips, a service centre
authorised by Philips or similarly qualified persons in order to avoid a hazard.
Keep the appliance out of the reach of children.
Never suck up water or any other liquid. Never suck up flammable substances and do not
suck up ashes until they are cold.
Do not point the hose at the eyes or ears nor put it in your mouth when the vacuum
cleaner is switched on and the hose is connected to the vacuum cleaner.
Sucking up large objects may cause the air passage in the tube or hose to become
obstructed. If this happens, the blockage indicator will turn red to indicate that there is an
obstruction that needs to be removed.
Never use the appliance without the Motor Protection Filter.This could damage the motor
and shorten the life of the appliance.
Only use the Philips filter cylinder supplied with the appliance.
Preparing for use
Connecting accessories
Hose
1 To connect the hose, push it firmly into the appliance ('click') (fig. 2).