Concept VI1010 Gebrauchsanweisung Seite 49

EN
WARNING!
• After cooking has finished, there is residual heat in the glass-ceramic plate coming from the cooking utensil. Pay extra
attention as the heat zone is hot and you can be burnt. This residual heat can be utilised.
• The touch control is activated by placing a finger on the required symbol on the glass-ceramic plate. Therefore, keep the
control panel clean and dry.
• The sensors do not respond to matt, dark colours (do not use black gloves). Do not place anything on the control panel
of the hob.
• Make sure the appliance is prevented from being accidentally switched on, e.g. by kids or pets.
• When the hob is disconnected from the mains, the set-up parameters are reset.
Prior to first use
Prior to operating a new appliance for the first time, wipe the top glass-ceramic plate with a wet cloth.
1. Place the appliance on a stable, heat-resistant surface away from other heat sources.
2. Unwind the entire supply cable. Make sure it is not in contact with any heat sources nearby. Insert the plug into the
electric voltage outlet.
3. Check to ensure that the surrounding of the air inlet/outlet grids are open and that there is no danger of the grids
clogging or sucking in an object.
4. Remove small metal items from the surroundings of the appliance; they can become hot or magnetised (Fig. 1).
5. Place the cooking utensil containing food in the centre of the heat zone. Use a utensil with a diameter of 120 to 260
mm (210 mm is the best). The safety fuse prevents utensils with a diameter less than 120 mm from heating to avoid
the unwanted heating of other metallic items, such as nearby cutlery, spoons, and other items.
6. To switch on the hob, press the ON/STANDBY symbol (1). If you do not make a further selection within 1 minute, the
hob automatically switches off.
7. The appliance is equipped with 2 methods of setting up the heat zone power level; you can select one of them by
touching the Function symbol (6) (the indicator at the respective scale turns on):
a) Power = According to input:
Set up the required power level by repeatedly pressing the „ +" or „ -" symbol (4) until you reach the required value. The
initial position is set at „ Mid".
As soon as the food starts to boil, turn down the control knob so that it will keep the food simmering.
b) Temp = According to required temperature:
While frying, you can use the set-up according to the required temperature (the indicated value is measured at the
bottom of the cooking utensil and may differ from the actual food temperature).
Set the required temperature by repeatedly pressing the „+" or „-" symbol (4) until you reach the required value. The
initial position is set at 180°C.
Note: If the utensil's diameter is too small, or the utensil is made of an unsuitable material, an intermittent sound
signal (beeping) is heard. Use a utensil with a larger bottom diameter or a utensil made of a different material. If you
VI1010
(Fig. 1)
47