Herunterladen Inhalt Inhalt Diese Seite drucken

Chicco Ducati 1199 Custom Bike Bedienungsanleitung Seite 9

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 14
Diag. F Recharging system
INTRODUCTION TO THE TOY
This toy is an electrically charged vehicle which is activated by "pressing" the tail of the motorbike. The more
times the motorbike is pressed into the ground, the further it will travel.
It is also possible to use the motorbike in two different modes: racing mode and road mode
nly;
This changeover is possible thanks to the 2 fairings, 2 removable tyres and the carburettor switch which
changes the sound of the engine.
HOW TO USE THE TOY
1. Turn the motorbike ON by moving the ON/OFF lever switch (Diag. B-8) under the bike to the II position.
and
2. Charge the motorbike by pressing it downwards (Diag. F)
3. When it has charged, the motorbike will start off in a straight line. The more times the motorbike is pressed
ould
towards the ground, the further it will travel.
4. Always switch the toy OFF when it is not being used, moving the lever to (Diag. B-8) to O.
CHANGING THE FAIRING
1. Press the yellow button (Diag.C-10) to release the fairing from the motorbike.
2. Remove the fairing and mount the different coloured one, making sure it is fitted correctly and firmly locks
in position, as seen in Diag. C-11.
ably
CHANGING THE TYRES
1. Use the spanner to turn the yellow rod on the tyre clockwise (Diag. A-7) as seen in Diag. D-12. The tyre
mounted on the motorcycle will automatically be released.
2. Mount the other tyre following the instructions seen in Diag. D-13, until it locks firmly in position.
CHANGING CARBURETTOR
To change the engine sound, simply move the carburettor switch (Diag. E-14) to either of the two positions (as
seen in Diag. E-15), using the screwdriver (Diag. A-6).
FITTING AND/OR REPLACING BATTERIES
Batteries must only be replaced by an adult.
• To replace the batteries: loosen the screw on the battery compartment cover (Diag. B-9) with a screwdriver
and open the cover. Then remove the spent batteries and fit new ones, ensuring that they have been fitted
with correct polarity (as shown on the product), close the battery cover, and tighten the screw.
• Only use alkaline batteries of the same type or equivalent to the type recommended for the correct function
of this product.
• Never mix alkaline, standard (zinc-carbon) or rechargeable (nickel-cadmium) batteries.
• Never mix new and old batteries.
• Always keep batteries and tools out of the reach of children.
• Do not short-circuit the battery terminals.
• Always remove spent batteries from the product to avoid the danger of leakage from the battery damaging
the product.
• Always remove the batteries if the product will not be used for a long period of time
• Remove the batteries from the toy before disposing of the product.
• Do not burn or dispose of old batteries into the environment; dispose of them at an appropriate differenti-
ated collection point.
• If the batteries happen to leak liquid, replace them immediately, making sure you clean the compartment
beforehand; wash your hands thoroughly if you come into contact with any such liquid.
9

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis