Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Install the LM.125 / .250 and associated components as follows:
1.
Mount the LM.125 / .250 (see page 2)
2.
Mount the cable reel (see page 4)
3.
Mount the steel cable on the cable reel (see page 4)
4.
Mount the CE protection cover on the cable reel (see page 5)
5.
Mount the belt drum and belt (see page 6)
6.
Mount the CE protection cover on the belt drum (see page 6)
7.
Mount the pipe / chain coupling (see page 7)
8.
Set the stroke length (see page 7)
9.
Connect the LM.125 / .250 (see page 10)
10. Test the LM.125 / .250 (see page 10)
Never place the LM.125 / .250 in a place where the weather has direct influence (not in the sun, not in
places where the temperature can rise sharply etc.).
Place the LM.125 / .250 at such a height that the manual control can be used.
Mount the actuator on a solid and safe surface.
When mounting, the corresponding LM mounting kit can be used. Otherwise, mark the drilling holes
using the drilling jig supplied with the actuator.
Seal the gland nuts after mounting to prevent the entry of moisture, dust and/or aggressive gases.
Never mount the actuator in the following position:
Gnd
g
2
Werbung
