Werbung
Verfügbare Sprachen
Verfügbare Sprachen
The direction of rotation of the propulsion motor can be reversed. This possibility is used whenever the connection
has been made in the opposite direction.
Don't switch the CPS wires. This will damage the CPS.
Adjust the CLOSE cam disc of a LM.125 / .250 motor against the upper side of the CLOSE limiting
switch.
Adjust the OPEN cam disc of a LM.125 / .250 motor against the lower side of the open limiting switch.
To reverse the direction of rotation, perform the following steps:
LM.125 / .250 single phase
1.
Switch off the power.
2.
Open the cover of the reduction gear unit (reductor).
3.
Change over the
motor open
4.
Follow the instructions according to the reverse rotation mentioned in the IMS manual.
5.
Close the cover of the reduction gear unit.
6.
Switch on the power.
LM.125 / .250 three phase
1.
Switch off the power.
2.
Open the cover of the reduction gear unit (reductor).
3.
Change over the two phases, e.g.
4.
Follow the instructions according to the reverse rotation mentioned in the IMS manual.
5.
Close the cover of the reduction gear unit.
6.
Switch on the power.
and
motor close
connection (terminal 1 and 2) of the motor connection terminal.
U1
and V1.
Gnd
g
14
Werbung
