Pioneer XW-BTS7-T Bedienungsanleitung Seite 14

Pairing with Bluetooth Device with NFC function
1. Press [BT/AUX] button on the remote control. (BT/AUX indicator: Blue)
2. The unit would be in Pairing mode for first time and the BT/AUX indicator would be
blinking in blue.
3. Turn on the NFC function of your Bluetooth device.
4. Place your device surface near the NFC sensor area of the unit.
• Remark: check the NFC antenna position of your Bluetooth device and place it close to the
NFC sensor of the unit
5. Your mobile device would turn on and connect with the speaker automatically.
• Remark: Some device screen may pop up message to confirm the speaker connection, select
YES to accept it.
• Pairing begins.
6. When Bluetooth wireless technology device is connected, the blue indicator on the top
Panel will change from blinking to lit.
7. Start playback of music contents stored in Bluetooth wireless technology device.
8. To disable the connection, just place your device surface near the NFC sensor area of
the speaker again or turn of the Bluetooth connection at your device, the unit then
would go to pairing mode.
Pairing with Bluetooth Device without NFC function
1. Press [BT/AUX] button on the remote control. (BT/AUX indicator: Blue)
2. The unit would be in Pairing mode for first time and the BT/AUX indicator would be
blinking in blue
Press and hold
the blue indicator on top panel blinks quickly and the unit will enter the pairing mode.
3. Switch on the Bluetooth wireless technology device that you want to perform pairing
with, place the device within 1 m (3.2 ft.) of the system, and set it to the pairing mode.
Pairing begins.
In case of entering PIN code, use "0000".
( Only "0000" works for PIN code in this product. )
4. When Bluetooth wireless technology device is connected, the blue indicator on the top
panel will change from blinking to lit.
5. Start playback of music contents stored in Bluetooth wireless technology device.
Connect the Latest Paired Bluetooth wireless technology Device
When the unit is switch on again to Bluetooth mode next time, it will be connected automatically
with equipment that has the latest connected device already.
Bluetooth Audio playback
[PAIRING] button until you hear 2 consecutive "beep" sounds. Then,
14