IFM Electronic AC2264 Montageanleitung Seite 6

Addressing
Assign a free address between 1 and 31. At the factory the address is
set to 0.
Addressing with the addressing unit AC1154
When mounted and wired the module can be addressed by connect-
ing the addressing cable (E70213) to the implemented addressing
socket.
Do not remove the addressing plug while live.
If the slave is used with a master of the new generation (version 2.1),
an address between 1A and 31B can be selected by means of the
addressing unit AC1154.
If a slave with the ID code "A" (option of extended addressing mode)
is connected to a master of the first generation (version 2.0), the para-
meter P3 must be 1 and the output bit D3 = 0*. The output bit D3
must not be used.
If a slave with the ID code "A" (option of extended addressing mode)
is connected to a master of the first generation (version 2.0), an
address between 1A and 31A must be assigned to this slave.
* default setting
6