Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
As soon as you try to switch to a channel between 41 and 80 in AM, the radio
automatically switches to the 40 channel AM mode with the channels 1 to 40 (and reverse
in the German setting) Both modulation types have their own channel setting, so after a
swap you always come back to your last used AM respectively FM channel.
ASQ
Automatic SQuelch on/off. Different from the standard squelch circuit, the ASQ switch
position is a fixed signal-to noise related automatic squelch level selection, which allows a
very sensitive receiving of all audible signals without any further adjustment. In cases,
where You desire to suppress more distant stations, You should use the "standard"
squelch control instead of ASQ.
MIC
Microphone gain amplifier- allows an increased gain of the microphone amplifier and more
modulation sensitivity at a larger distance from the microphone. MIC should not be used in
a very loud environment.
RB
Roger beep on/off: press BP. The roger beep is a sound signal, which the distant party
will hear after ending a transmission. It is very helpful if a radio connection gets
weaker. The partner station can hear the roger beep easier in presence of noise
and knows that the other one has stopped talking.
BP
key sound on/off These are the short sound you hear when you press a button.
CH/SC Rotary channel knob with additional push button on the knob. Rotating knob = channel
switching, push button = Scan mode start/stop
SCAN Scanning busy channels on/off: press CH / SC shortly (about 1 second). Now the
scanning of all channels starts. Here all channels are scanned one after another. When
the scan function recognizes a busy channel the scan stops so that you can listen to the
conversation (including short interruptions). Important for the scan is to adjust the
squelch level so the scan only stops on channels who are really busy. About 10 seconds
after a conversation has stopped, the scan will go on as well as when the signal is too
weak and falls under the adjusted squelch level.
If CTCSS is switched on, the scan only reacts on signals which use the selected
CTCSS code.
Stop scan: press SC longer or press the PTT button shortly.
16
Werbung
Inhaltsverzeichnis
