Appendix; Gauge Technical Data; Gauge Mechanical Data; Gauge Electrical Data - Automation Dr. Nix QNix 5500 Betriebsanleitung

5500

7 Appendix

7.1 Gauge Technical Data

7.1.1 Gauge Mechanical Data

Mechanical Data
Display IPS-LCD, 2", colour, 600 lm,
viewing angle 70° in all directions
Dimensions (L x W x H) Approx. 160 mm x 68 mm x 38 mm
Weight (without batteries) Approx. 270 g
Robustness / ambient conditions
IP rating IP65
Operating temperature -20 °C to +70 °C
Storage temperature -20 °C to +70 °C

7.1.2 Gauge Electrical Data

Electrical data
Protection rating III
Device power supply 2 x batteries 1,5 V (type AA)
Battery life without operation at min. > 1 year
50% battery capacity
Battery life at one measurement per min. 60 000 measurements
second

7.2 Probe Technical Data

7.2.1 Probe mechanical data

Mechanical Data
Upper housing material Stainless steel (1.4305)
Bottom housing material Trogamid® (CX7323)
Test prod material polished ruby (Al203)
Dimensions (length / diameter) 35.5 mm / 14.5 mm
Weight 11.9 g
20 20 / 31
7 Appendix
QNix 5500 EN_ES_FR_IT_NL_PL
7 Appendix
Robustness / ambient conditions
IP rating IP65 (closed)
Operating temperature -20 °C to +70 °C
Storage temperature -20 °C to +70 °C
Max. surface temperature in 80 °C
continuous measurement mode
Max. surface temperature at 1s test 100° C
time ever 20s

7.2.2 Probe Electrical Data

The probes may only be used with the gauges QNix® 9500 and QNix®5500.

7.3 Measuring Data

Measuring Data Fe
Principle of Measurement Magnetic field principal
Magnetic field change,
Hall effect
As per standard (varies by model) DIN EN ISO 2808,
DIN EN ISO 2178
DIN 50981, DIN 50984, BS 5411 (3 & 11), BS 3900-C5,
ASTM B 499, ASTM D 1400, ASTM D 1186, ASTM D 7091
Status indication By RGB-LED at the probe
Probe type See probe data sheet
Measuring range Varies by probe type
Measuring interval >= 100 measurements / min
Units µm / mil (setting in battery compartment)
Display resolution 0.1 µm
Measurement uncertainty* ± (1 µm + 2 %) up to 2 mm
(based on factory standards) ± 3 % from 2 mm
Minimum measuring area (Ø) 14.5 mm
Minimum curvature radius, convex 6 mm
Minimum thickness of the 100 µm
base material
* Accuracy may deviate outside a range of -5 °C to 65 °C, but not more than the factor 2 of the
measurement uncertainty.
QNix 5500 EN_ES_FR_IT_NL_PL
5500
NFe
Magnetic field principal
Eddy current
DIN EN ISO 2808,
DIN EN ISO 2360
± (2 µm + 2 %) up to 2 mm
± 3 % from 2 mm
14.5 mm
50 mm
50 µm
21 / 31 21