Measure; Troubleshooting; Service And Repair - Automation Dr. Nix QNix 5500 Betriebsanleitung

5500
Section Symbol Description
Status bar Calibration done
Battery level 100 % / 50 % / 25 % / empty
Note! When the batteries are below 50 %, a warning
screen will appear. Press "OK" to confirm the screen and
replace the batteries promptly.
Probe status bar Probe connected
Measurement display n: Total number of measurements
µm / mil Unit for the coating thickness
n-1: Last and next to last measurement
n-2:
NFe / Fe Actual substrate
Analysis area Average
x-max Highest measurement
x-min Lowest measurement
σ Standard deviation

4.4 Measure

> If necessary, start zero-adjustment.
> Apply the probe and take a measurement.
Sensor ring colours
> Green: measurement taken
> Blue: measurement range exceeded
18 18 / 31
4 Operation and Controls
QNix 5500 EN_ES_FR_IT_NL_PL

5 Troubleshooting

5 Troubleshooting
If the device is not responding as expected, please check the following items:
Error Possible Cause
Device doesn't switch on Batteries drained
Calibration with reference plates Incorrect reference plate selec-
produces implausible ted
results
Device or probe defective
Sensor ring lights up blue Measuring range exceeded
Sensor ring briefly lights up blue No error
during probe change
(no error)

6 Service and Repair

The equipment must be repaired by our service partners or by a manufacturer authorised techni-
cian.
If you have any questions, please contact your local retailer or our Support:
www.q-nix.com/support
Automation Dr. Nix GmbH & Co KG
Robert-Perthel-Strasse 2
50739 Cologne
Germany
Tel.: +49 (0)221 91 74 55-0
Fax.: +49 (0)221 17 12 21
info@automation.de
QNix 5500 EN_ES_FR_IT_NL_PL
5500
Action
Replace the batteries or connect
the device to a USB connection.
Select the reference plate
Fe/NFe based on your probe.
Please contact your authorised
service location.
Probe is connected correctly.
19 / 31 19