Operation; Maintenance - Husqvarna CA230 Bedienungsanweisung

WARNING: Always stop the product before
you work on any part of the attachment. It
can continue to move even after the throttle/
power trigger is released. If you have a
gasoline operated product, disconnect the
HT leads from the spark plug. If you have a
battery operated product, remove the
battery. Ensure the attachment has stopped
completely before you start to work on it.
• Cultivating should only be done in daylight or other
well-lit conditions.
• Check the entire product before starting. Replace
damaged parts. Check that all guards and covers
are complete and fastened securely. Check all nuts
and screws.
• If you have a gasoline operated product, make sure
that there are no fuel leaks.
• Check that the blades are undamaged and show no
signs of cracking or other damage. Replace the
blades if necessary.
• Make sure the cutter guard is fitted and not
damaged.
To start the product with a cold engine
If you have a gasoline operated product, obey these
instructions to start the product with a cold engine.
Introduction
Below you will find some general maintenance
instructions. If you need further information please
contact your service workshop.
240
• Check that the tines and tine guard are secured
correctly. Make sure the direction of rotation agrees
with the cutters and on the gear. The arrows must
point in the same direction.
• Check that the blades do not move when the throttle/
power trigger is released.
• Make sure the handle and safety features are in
order. Never use a product that has any parts
missing or has been modified in relation to the
specification.
• Only use the product for the purpose it was intended
for.
• Make sure the cutting attachment has stopped
before cleaning, carrying out repairs or an
inspection. If you have a gasoline operated product,
disconnect the HT leads from the spark plug. If you
have a battery operated product, remove the battery.
• Wear heavy-duty gloves when repairing the
cultivator.
• Use only original spare parts for repairs.
• Store the product out of reach of children.
SAVE THESE
INSTRUCTIONS

Operation

1. Run the basic product warm and then shut down the
product.
2. Mount the accessory as per the assembly
instructions.

Maintenance

To replace the blades
WARNING: Always stop the product before
you work on any part of the attachment. It
can continue to move even after the throttle/
power trigger is released. If you have a
742 - 002 - 13.12.2019