Husqvarna CA230 Bedienungsanweisung Seite 238

• Make sure your hands and feet do not come near
the cutter when the engine/motor is running.
• Always keep the tines close to the ground.
• Always release the throttle/power trigger after each
working operation. Long periods at full throttle/speed
without any load on the engine/motor (i.e. without the
resistance that the cutting attachment exerts on the
engine when you are using the product) can lead to
serious engine/motor damage.
• Pay extra attention when pulling the cultivator
towards you while working.
• If heavy vibration occurs, stop the product. If you
have a gasoline operated product, disconnect the HT
lead from the spark plug. If you have a battery
operated product, remove the battery. Check that the
product is not damaged. Repair any damage.
• Keep hands away from blades.
Other safety information
• Avoid Dangerous Environment – Don't use
appliances in damp or wet locations.
• Don't Use In Rain.
• Keep Children Away – All visitors should be kept at a
distance from work area.
• Dress Properly – Do not wear loose clothing or
jewelry. They can be caught in moving parts. Use of
rubber gloves and substantial footwear is
recommended when working outdoors. Wear
protective hair covering to contain long hair.
• Use Safety Glasses – Always use face or dust mask
if operation is dusty.
• Use Right Appliance – Do not use appliance for any
job except that for which it is intended.
• Avoid Unintentional Starting – Don't carry plugged-in
appliance with finger on switch. Be sure switch is off
when plugging in.
• Don't Force Appliance – It will do the job better and
with less likelihood of a risk of injury at the rate for
which it was designed.
• Don't Overreach – Keep proper footing and balance
at all times.
• Stay Alert – Watch what you are doing. Use common
sense. Do not operate appliance when you are tired.
• Store Idle Appliances Indoors – When not in use,
appliances should be stored indoors in dry, and high
or locked-up place – out of reach of children.
• Maintain Appliance With Care – Keep cutting edge
sharp and clean for best performance and to reduce
the risk of injury. Follow instructions for lubricating
238
and changing accessories. Keep handles dry, clean,
and free from oil and grease.
• Check Damaged Parts – Before further use of the
appliance, a guard or other part that is damaged
should be carefully checked to determine that it will
operate properly and perform its intended function.
Check for alignment of moving parts, binding of
moving parts, breakage of parts, mounting, and any
other condition that may affect its operation. A guard
or other part that is damaged should be properly
repaired or replaced by an authorized service center
unless indicated elsewhere in this manual.
Personal protective equipment
WARNING: Read the warning instructions
that follow before you use the product.
• Always use approved personal protective equipment
when you use the product. Personal protective
equipment cannot fully prevent injury but it
decreases the degree of injury if an accident does
occur. Let your dealer help you select the right
equipment.
• Use approved hearing protection that provides
adequate noise reduction. Long-term exposure to
noise can result in permanent hearing impairment.
• Use approved eye protection. If you use a visor, you
must also use approved protective goggles.
Approved protective goggles must comply with the
ANSI Z87.1 standard in the USAs or EN 166 in EU
countries.
• Use gloves when necessary, for example when you
attach, examine or clean the cutting equipment.
742 - 002 - 13.12.2019