Operation Tve43 - Hoover TVX33 Reverse Action Gebrauchsanleitung

05651114.qxd 24-05-02

Operation TVE43

1. Open the door and load the drum with
laundry. Ensure that garments do not
hinder closure of the door.
2. Gently close the door pushing it slowly
until you hear the door 'click' shut.
3. Press the 'ON/OFF' button to switch on
the dryer. The indicator will light.
4. Turn the 'PROGRAM' dial to select the
required drying program:
e.g. if you are drying cotton laundry and
would like it suitable for ironing please
select the iron dry option.
The PRE-IRONING setting shown by
the symbol
dial provides a conditioning and anti-
crease function. The dryer will heat the
load for 9 minutes followed by a 3
minute cool down period and is
especially good for garments which may
have been left for some time prior to
ironing, in a linen basket for example.
Garments may also become stiffened
when dried outside on a washing line or
inside on radiators. The PRE-IRONING
process relaxes the creases in the fabric
making ironing quicker and easier.
13:53 Page 11
Airing
Pre-iron
on the 'PROGRAM'
5. If drying delicate items on the 'timed'
programs press the 'HEAT SETTING'
button to reduce the heat level. Press
again on completion, to select high
temperature.
HIGH Heat setting
LOW Heat setting
6. Press the 'START' button. The dryer
will start automatically and the
'HEATING' indicator will light.
Drying sensor
A sensor will detect when the load is
dry. The drying cycle will then go into
the cooldown period and the
'COOLING' indicator will light.
After 10 minutes of cooldown the drum
will stop rotating automatically.
Note:
(i) The sensor may not detect a small
load of small articles. For small loads
and separate items or pre-dried
fabrics with low moisture content,
utilise the timed programs. Set the
program between 30 and 75 minutes
depending upon load size and dryness
required and select high or low heat
depending upon the fabric type. If
this is not carried out the dryer will
only operate for 10 minutes before
going into cooldown.
(ii) If the sensor does not operate, for
example when a load is too large or
too wet to tumble dry, the dryer will
automatically go into cooldown after
180 minutes.
The dryer can be set to start up to 9
hours after the program has been set.
To set the time delay option press and
release the 'START DELAY' button until
the required delay (shown in hours)
appears on the display and then press the
'START' button. The display will flash.
ENGLISH
11