Saf-Fro DIGISTEEL 255C Bedienungsanleitung Seite 24

Access Control
This function allows following activities
Table 14.
Symbol Description
Lock
Lock function
Enable/ Disable Jobs
Select Jobs for Job Work
Lock – it allows to set the password. To set
the password:

Access to the Settings and Configuration
Menu.

Use the Right Knob [36] to highlight the Lock icon.
Figure 43.

Press the Right Knob [36]. The password setting
menu is shown on the display.
Figure 44.

Turn Right Knob [36] to select: numbers 0-9,
Press Right Knob [36] to confirm first character of the
password.

Next numbers are selected in the same method.
Note: After setting last character system exit
automatically.
English
Lock function – it allows to lock/unlock some
functions on welding parameters bar.
To lock functions:

Access to the Settings and Configuration Menu.

Use the Right Knob [36] to highlight the Lock
functions icon.

Press the Right Knob [36]. The Lock Function menu
is shown on the display.

Use the Right Knob [36] to highlight the function (for
example "Advanced setup").

Press the Right Knob [36]. The icon of chosen
parameter will disappear from the lower part of the
display (Figure 47). Also this parameter disappear
from the Welding parameters bar [44].
Note: To unlock function user have to do the same
steps as steps to lock function.
Enable/ Disable Jobs – it allows to switch
off/on jobs to function Save Memory.
To enable/ disable jobs:

Access to the Settings and Configuration Menu.

Use the Right Knob [36] to highlight the icon:
21
Figure 45.
Figure 46.
Figure 47.
English