Specifications - Makita JR100D Bedienungsanleitung

ENGLISH (Original instructions)
1-1. Buttons
1-2. Battery
2-1. Lock-off button
2-2. Lock-off lever
2-3. Switch lever
2-4. Switch trigger
3-1. Lamp

SPECIFICATIONS

Length of stroke
Strokes per minute (min
Max. cutting capacities
Overall length (with battery)
• Due to our continuing program of research and development, the specifications herein are subject to change without notice.
• Specifications and battery cartridge may differ from country to country.
• Weight, with battery cartridge, according to EPTA-Procedure 01/2003
Intended use
The tool is intended for sawing wood, plastic and ferrous
materials.
Noise
The typical A-weighted noise level determined according
to EN60745:
Model JR100D
Sound pressure level (L
Uncertainty (K) : 3 dB(A)
The noise level under working may exceed 80 dB (A).
Model JR102D
Sound pressure level (L
Uncertainty (K) : 3 dB(A)
The noise level under working may exceed 80 dB (A).
Wear ear protection
Vibration
The vibration total
determined according to EN60745:
Model JR100D
Work mode : cutting boards
Vibration emission (a
Uncertainty (K) : 1.5 m/s
Work mode : cutting wooden beams
Vibration emission (a
Explanation of general view
4-1. Recipro saw blade
4-2. Blade clamp sleeve
5-1. Blade clamp sleeve
5-2. Saw blade
6-1. Hex wrench
6-2. Bolt
6-3. Loosen
Model
-1
)
Pipe
Wood
Net weight
Rated voltage
) : 78 dB(A)
pA
) : 77 dB(A)
pA
value (tri-axial vector
2
) : 9.5 m/s
h,B
2
2
) : 9.5 m/s
h,WB
JR100D
1.2 kg
ENE020-1
Uncertainty (K) : 2.5 m/s
Model JR102D
Work mode : cutting boards
ENG905-1
Vibration emission (a
Uncertainty (K) : 1.5 m/s
Work mode : cutting wooden beams
Vibration emission (a
Uncertainty (K) : 1.5 m/s
The declared vibration emission value has been
•
measured in accordance with the standard test
method and may be used for comparing one tool
with another.
The declared vibration emission value may also be
•
used in a preliminary assessment of exposure.
WARNING:
The vibration emission during actual use of the
•
power tool can differ from the declared emission
ENG900-1
value depending on the ways in which the tool is
used.
sum)
Be sure to identify safety measures to protect the
•
operator that are based on an estimation of
exposure in the actual conditions of use (taking
account of all parts of the operating cycle such as
the times when the tool is switched off and when it
is running idle in addition to the trigger time).
3
6-4. Tighten
7-1. Saw blade
7-2. Blade clamp
7-3. Hole for recipro saw blade
7-4. Hole for jig saw blade
9-1. Hex wrench
9-2. Projections
JR102D
13 mm
0 - 3,300
50 mm
50 mm
355 mm
1.1 kg
D.C. 10.8V
2
2
) : 8.0 m/s
h,B
2
2
) : 7.0 m/s
h,WB
2
ENG901-1