Optional Accessories - Makita DBN600 Betriebsanleitung

NOTE: If you drive nails continuously for a long time,
the exhaust air will get hot due to the heat from the
motor.
The tool employs two nailing actions: intermittent nailing
(sequential mode) and continuous/intermittent nailing
(continuous mode).
► Fig.15: 1. Switch trigger 2. Contact element
3. Mode selecting switch 4. Sequential
mode 5. Continuous mode
Intermittent nailing (sequential mode)
1. Set the mode selecting switch to the sequential
mode.
2.
Release the trigger lock.
3.
Place flat the contact element on the material.
4. Pull the switch trigger fully to drive a nail.
5. To drive the next nail, release the switch trigger
and contact element once, and then repeat the step 3
and 4 above.
WARNING:
Always be sure to first place the
contact element against the workpiece before
pulling the trigger.
Continuous/intermittent nailing
(continuous mode)
1.
Set the mode selecting switch to the continuous
mode.
2. Release the trigger lock.
3. Pull the switch trigger first and then place the
contact element against the workpiece.
4. To drive the next nail, keep your finger pulling the
switch trigger and place the contact element against the
workpiece again.
NOTE: This tool stops automatically under the follow-
ing conditions:
• When you release the switch trigger or contact
element from workpiece before the tool finishes
the operation completely. In this case, pull the
trigger again until the tool turns into standby.
• When keeping either pulling the switch trigger
or placing the contact element about 5 seconds
without another action. In this case, release the
switch trigger or the contact element from work-
piece to restart the operation.
Anti dry fire mechanism
When the remaining nails in the magazine decrease to
6 - 9 pieces, the switch trigger can no longer be pulled.
At this time, insert a new strip of nails in the magazine
and the switch trigger can be pulled again.
Removing jammed nails
WARNING:
Always make sure that the battery
cartridge is removed before removing jammed
nails.
CAUTION:
Be sure to lock the latch after
removing jammed nails.
Release the latch and open the door. Remove the
jammed nails and lock the latch.
► Fig.16: 1. Latch 2. Door
Handling of the nails
Handle nails and their box carefully. If the nails have
been handled roughly, they may be out of shape or their
connector breaks, causing poor nail feed.
NOTICE:
Avoid storing nails in a very humid or
hot place or place exposed to direct sunlight.
► Fig.17
MAINTENANCE
CAUTION:
Always be sure that the tool is
switched off and the battery cartridge is removed
before attempting to perform inspection or
maintenance.
NOTICE:
Never use gasoline, benzine, thinner,
alcohol or the like. Discoloration, deformation or
cracks may result.
To maintain product SAFETY and RELIABILITY,
repairs, any other maintenance or adjustment should
be performed by Makita Authorized or Factory Service
Centers, always using Makita replacement parts.
OPTIONAL
ACCESSORIES
CAUTION:
These accessories or attachments
are recommended for use with your Makita tool
specified in this manual. The use of any other
accessories or attachments might present a risk of
injury to persons. Only use accessory or attachment
for its stated purpose.
If you need any assistance for more details regard-
ing these accessories, ask your local Makita Service
Center.
• Nails
• Makita genuine battery and charger
• Safety goggles
NOTE: Some items in the list may be included in the
tool package as standard accessories. They may
differ from country to country.
10 ENGLISH