Fein SCT5-40X Bedienungsanleitung Seite 12

OBJ_BUCH-0000000389-001.book Page 12 Monday, August 19, 2019 3:14 PM
en
12
Original Instructions. en
Symbols, abbreviations and terms used.
Symbol, character Explanation
Do not touch the rotating parts of the power tool.
Observe the instructions in the text or graphic opposite!
Make sure to read the enclosed documents such as the Instruction Manual and the
General Safety Instructions.
Before commencing this work step, pull the mains plug out of the socket. Otherwise
there will be danger of injury if the power tool should start unintentionally.
Use eye protection during operation.
Observe the information in the adjacent text!
Gripping surface
Switching on
Switching off
Confirms the conformity of the power tool with the directives of the European
Community.
This sign indicates a possible dangerous situation that could cause severe or fatal injury.
WARNING
Worn out power tools and other electrotechnical and electrical products should be
sorted separately for environmental-friendly recycling.
Product with double or reinforced insulation
Low speed
High speed
Reduce torque
Increase torque
(**) may contain numbers and letters
(Ax – Zx) Marking for internal purposes
Character Unit of measure-
ment, international
P
W
1
P W
2
U
V
f
Hz
-1
n
/min, min
0
r/min
-1
n
/min, min
1
r/min
M...
Nm
mm
mm
Unit of measure-
ment, national
W
W
V
Hz
, rpm, rpm
, rpm, rpm
Nm
mm
mm
Explanation
Power input
Output
Rated voltage
Frequency
No-load speed
Speed, full load
Torque
Hexagon socket tool holder
Screw diameter