Installation Procedure For Windows 2000 - Belkin F5U222 Benutzerhandbuch

Installation

Installation Procedure for Windows 2000

This installation procedure will install two USB 1.1 OHCI controllers and one
USB 2.0 EHCI host controller.
Important Note: There are two methods of installing the required USB 2.0
drivers in Windows 2000.
EN
1. If you have an Internet connection:
Windows 2000 will allow you to link to the Windows update website and
download the most recent version of the Microsoft USB 2.0 support driver.
Please proceed to the "Installing the Microsoft Driver" section.
2. If you do not have an Internet connection:
USB 2.0 drivers will be installed from the Belkin Driver Installation CD.
Please proceed to the "Installing the Belkin Driver" section.
Installing the Microsoft Driver
1. Locate your computer's CardBus slot.
2. Insert the Notebook Card into the slot. Apply pressure as needed until the
Card is fully seated.
3. Turn on your computer.
4. After Windows has finished loading, the installation process will begin.
Note: Do not plug any devices into the Notebook Card until driver installation is
completely finished.
10 10