Specifications - Ingersoll-Rand 325 Bedienungsanleitung

FAILURE TO OBSERVE THE FOLLOWING WARNINGS COULD RESULT IN INJURY.
WARNING
Always wear eye protection
when operating or perform-
ing maintenance on this tool.
WARNING
Air powered tools can vibrate
in use. Vibration, repetitive
motions or uncomfortable po-
sitions may be harmful to your
hands and arms. Stop using
any tool if discomfort, tingling
feeling or pain occurs. Seek
medical advice before resum-
ing use.
WARNING
Keep body stance balanced
and firm. Do not overreach
when operating this tool.
WARNING
Keep hands, loose clothing
and long hair away from
blades when operating this
cutter.
LUBRICATION
Ingersoll–Rand No. 50
Always use an air line lubricator with this tool.
We recommend the following Filter–Lubricator–Regulator
Unit:
C28–C4–FKG0
Before starting the tool and after each two or three
hours of operation, unless the air line lubricator is used,
pour approximately 1.5 cc of Ingersoll–Rand No. 50 Oil
into the air inlet.
Oil the Cutter (36) and Die (39) before and during use,
especially while cutting aluminum.
Model Weight
lb.
325, 325–EU 3
H
Tested in accordance with ANSI S5.1–1971 at free speed
♦ Tested in accordance with ISO8662–10
S
ISO3744
WARNING LABEL IDENTIFICATION
90 psig
(6.2bar/620 kPa)
PLACING TOOL IN SERVICE
Ingersoll–Rand No. 28

SPECIFICATIONS

Overall
Length
kg in mm
1.36 8 203
WARNING
Always wear hearing
protection when operating
this tool.
WARNING
Do not carry the tool by the
hose.
WARNING
Operate at 90 psig (6.2 bar/
620 kPa) Maximum air pres-
sure.
MAIN LINES 3 TIMES
AIR TOOL INLET SIZE
TO
AIR
SYSTEM
TO
AIR
TOOL
LUBRICATOR
REGULATOR
BRANCH LINE 2 TIMES
AIR TOOL INLET SIZE
DRAIN REGULARLY
Maximum Material
Thickness (Gauge)
Pressure
18
2
WARNING
Always turn off the air sup-
ply and disconnect the air
supply hose before install-
ing, removing or adjusting
any accessory on this tool,
or before performing any
maintenance on this tool.
WARNING
Do not use damaged, frayed
or deteriorated air hoses
and fittings.
International Warning Label:
Order Part No. ___________
FILTER
COMPRESSOR
(Dwg. TPD905–1)
♦Vibrations
GSound Level
dB (A) Level
SPower
92.3 105.3
2
m/s
7.0