Operation Via Remote Control - Silvercrest SEK 2000 A1 Bedienungs- Und Sicherheitshinweise

- Setting the brightness levels
Push this button to set various brightness levels. The
stair display on the display shows the currently
H
set step.
- Setting the heating levels
Push this button to set the heating levels.
The symbols on the display show the currently set
B
heating level.
1 LED = heating level 1 (900 W)
2 LEDs = heating level 2 (1850 W)
No LED = The appliance heating function is switched
off. The fan continues to run for 10 seconds.

Operation via remote control


REMOTE CONTROL:
INSERTING OR REPLACING THE BATTERY
A lithium button cell is supplied with the remote cont-
rol. To operate the remote control, remove the plastic
strap that protrudes from the battery compartment
(see Fig. 6)
6
If the battery in the remote control needs to be repla-
ced, insert a new 3-volt lithium button cell. Pay attention
to the type of lithium button cell (CR2025).
7
Press the tab on the remote control battery
12
compartment toward the centre. Now pull
13
14 GB/IE/NI
out the battery compartment
Remove the used battery.
Insert a new CR2025 3 V button cell, observing
the correct polarity.
Slide the battery compartment
remote control until the tab
8
.
13
- Switching on the
Push this button to start the preheating process. The
fire begins to blaze.
- Setting the day
Press this button to start the weekday setting. Use the
"+" and "-" keys to set the weekdays.
- Setting hours
After pressing this button, you can set the hours with
"+" and "-".
- Setting minutes
After pressing this button, you can set the minutes
with "+" and "-".
- Setting system time/timer
Press this button to set the current time, day of the week
or timer. Use the "+" and "-" keys to set the weekdays. To
set the hours and minutes, follow the description of each
. (See Fig. 7)
13
back into the
13
snaps into place.
12
Heating levels
Brightness
Day
Hours
Timer
Minutes
SET UP
Curved electric built-in fire: