Safety Notices - FLORABEST FHV 32 B2 Bedienungs- Und Sicherheitshinweise

List of pictograms used
Lock / Unlock
Hand Scarifier FHV 32 B2
Introduction
We congratulate you on the purchase of your new
product. You have chosen a high quality product.
Familiarise yourself with the product before using it
for the first time. In addition, please carefully refer
to the operating instructions and the safety advice
below. Only use the product as instructed and only
for the indicated field of application. Keep these in-
structions in a safe place. If you pass the product
on to anyone else, please ensure that you also
pass on all the documentation with it.
Intended Use
This product is suitable for removing moss, weeds
and lawn thatch to improve air circulation in the soil
and / or loosening the soil. The product is furnished
with 11 oscillating blades made from stainless steel.
The product is not intended for commercial use or
for any other use.
Parts Description
Wall mount
1
Handle (made up of 2 parts
2
Blade cylinder
3
Blade protective cover
4
Lock nut
5
Spring ring
6
Washer
7
Technical Data
Dimensions: approx. 200 x 45 cm
Working width: approx. 32 cm
Length (handle): approx. 180 cm
Weight:
Immediately after unpacking please check the pack-
age contents for completeness and if all parts and
the product are in good condition.
1 Blade cylinder (with blade guard)
1 Handle (two-piece)
1 Assembly material kit
1 Instructions for use
+ )
2 a 2 b
32 cm
approx. 2.5 kg
Scope of delivery

Safety Notices

CAUTION! SHARP BLADES!
DANGER OF WOUNDS!
Do not leave children unsupervised with the
product. Please ensure that children cannot
play with this product. This product is not a toy.
Keep your hands and feet away from the blades.
Wear sturdy shoes. Do not go barefoot or wear
open shoes when using the product.
Do not leave the product lying around on the
ground with the blades pointing upwards.
Place the blade protective cover on the blade
cylinder if you are not using the product.
Assembling the product (see Fig.)
Screw the two parts
2 a
together.
Attach the handle to the blade cylinder
2
Secure the screw connection using a lock nut
spring ring and washer
6
nut use a spanner (SW17) (not included).
5
Remove the blade protective cover
using the product.
, of the handle
2 b
.
3
,
5
. To fasten the lock
7
before
4
GB/CY 5