Setting The Sleep Timer; Factory Settings; Setting The Alarm Time - Peaq PDR110BT Bedienungsanleitung

ENGLISH
SETTING THE SLEEP-TIMER
After a pre-selected amount of time, this
unit can automatically change to standby
mode.
1. Select menu option [Sleep] with TUN/
CH and confirm with VOLUME/SE-
LECT.
2. Use TUN/CH to select the desired op-
tions:
• [Sleep Off]
• [10 minutes]
• [20 minutes]
• [30 minutes]
• [60 minutes]
• [70 minutes]
• [80 minutes]
• [90 minutes]

FACTORY SETTINGS

Select menu option [Factory reset] with
TUN/CH and confirm with VOLUME/SE-
LECT.
DISPLAYING THE SOFTWARE VERSION
Select menu option [Factory reset] with
TUN/CH and confirm with VOLUME/SE-
LECT.
36
_PDR110BT-B_160225_V05_A_HR.indb 36

SETTING THE ALARM TIME

Make sure the clock shows the correct
time.
1. Press ALARM button to choose fol-
lowing options:
• [Alarm 1 Setup]
• [Alarm 2 Setup]
2. Press VOLUME/SELECT to access
the Alarm Wizard.
3. On time: Set the hours and minutes
with TUN/CH and confirm with VOL-
UME/SELECT.
4. Set the alarm duration [Duration] with
TUN/CH and confirm with VOLUME/
SELECT.
• [15 mins]
The alarm sounds for 15 minutes.
• [30 mins]
The alarm sounds for 30 minutes.
• [45 mins]
The alarm sounds for 45 minutes.
• [60 mins]
The alarm sounds for 60 minutes.
• [90 mins]
The alarm sounds for 90 minutes.
5. Select the alarm tone [Source] with
TUN/CH and confirm VOLUME/SE-
LECT.
• [Buzzer]: Make the buzzer your
alarm tone.
• [DAB]: Make the most recent DAB +
station played your alarm tone.
• [FM]: Make the most recent FM
station played your alarm tone.
25/2/16 7:27 PM