Battery Replacement; Specifications - DePuy Mitek VAPR VUE Bedienungsanleitung

BATTERY REPLACEMENT

1. Turn the slotted screw (C) ¼ turn counter-clockwise.
2. Remove the battery cover (B) by gently prying with a
flat tip device in the recessed area near the screw.
Be careful to not damage the O-ring seal (D).
3. Remove and properly dispose of old batteries.
4. Insert 3 fresh "AA" alkaline batteries, observing the
polarity markings on the battery holder (G).
5. Observe the O-ring seal for any damage and
replace if necessary.
6. Carefully replace the battery cover, ensuring the
2 locking tabs (A) go into their seating position.
7. Press the battery cover down so it is flush with the
recessed lip.
8. Turn the slotted screw (C) ¼ turn clockwise.
9. Pairing of the footswitch to the VAPR VUE
generator should not be required after changing
batteries. If pairing is necessary, follow pairing
directions in the VAPR VUE User Manual.

SPECIFICATIONS

• Range: Typically 50 feet
• 2.405 - 2.480 GHz, Channels 1-15
• Latency: Typically 50 milliseconds
• Transmitter battery life: 400 hours @ 50% Duty
cycle. Typical Transmitter Stand-by current: 20μA.
Typical battery life is 1 year, based on average use.
• Degree of Ingress Protection: IP68 per EN 60529
• Transport & Storage Conditions
– Ambient Temperature Range:
14 to 104°F (–10 to 40°C)
– Relative Humidity:
10 % to 85%, non-condensing
– Atmospheric Pressure:
500 to 1060 millibars
• Operating Conditions
– Ambient Temperature Range:
7