General Information; Electromagnetic Interference - DePuy Mitek VAPR VUE Bedienungsanleitung

7. Ensure the pedals and mode button are not
depressed when stored. Battery life will be
significantly reduced.
INSTRUCTIONS FOR USE
Place the wireless footswitch in a clear, sealable
plastic bag prior to use. Refer to the VAPR VUE User
Manual on how to pair and operate the VAPR VUE
Wireless Footswitch with the VAPR VUE Generator.
Cleaning the VAPR VUE WIRELESS
Footswitch
The wireless footswitch is IP68 rated and can be
completely immersed briefly. Do not use abrasive
cloths, sharp objects, or abrasive cleaners. Dampen a
non-abrasive cloth with one of the following products;
then wring out until slightly wet and gently rub soiled
area until clean.
– Soap and water
– Cidex
– Sodium Hypochlorite 5.25% (Bleach) diluted 10:1
DO NOT AUTOCLAVE OR USE ETHYLENE OXIDE
on Wireless Footswitch

General Information

If the foot switch is cold to the touch or below ambient
temperature, allow it to reach room temperature
before use.

ELECTROMAGNETIC INTERFERENCE

• This device complies with part 15 of the FCC Rules
Operation is subject to the following two conditions:
– This device may not cause harmful interference
and
– This device must accept any interference
received, including interference that may cause
undesired operation.
• This equipment complies with FCC radiation exposure
limits set forth for an uncontrolled environment. End
users must follow the specific operating instructions for
4