DePuy Mitek VAPR VUE Bedienungsanleitung Seite 6

satisfying RF exposure compliance. This transmitter
must not be co-located or operating in conjunction with
any other antenna or transmitter.
• Changes or modifications not expressly approved by
the party responsible for compliance could void the
user's authority to operate the equipment.
• This device has been tested and found to comply
with the limits for medical devices to the EN 60601-
1-2, Medical Device Directive 93/42/EEC. These
limits are designed to provide reasonable protection
against harmful interference in a typical medical
installation. However, because of the proliferation of
radio-frequency transmitting equipment and other
sources of electrical noise in the health-care and
home environments it is possible that high levels of
such interference due to close proximity or strength
of a source may result in disruption of performance
of this device.
• This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and
used in accordance with these instructions, may
cause harmful interference with other devices in the
vicinity. Disruption or interference may be evidenced
by erratic or incorrect functioning. If this occurs,
the site of use should be surveyed to determine
the source of this disruption, and actions taken to
eliminate the source. The user is encouraged to try
to correct the interference by one of the following
measures:
– Turn equipment in the vicinity off and on to
isolate the offending equipment.
– Reorient or relocate the other receiving device.
– Increase the separation between the interfering
equipment and this equipment.
– If assistance is required, contact your
DePuy Mitek Representative.
• The wireless footswitch, in conjunction with the
DePuy Mitek VAPR VUE generator, has been tested
and found to properly operate in the presence of the
following potentially interfering devices:
– Electrosurgery generators – located on the same
cart as the VAPR VUE generator
5