VONROC MS503AC Bersetzung Der Originalbetriebsanleitung Seite 12

EN
8. Fence
9. Table extension
10. Table
11. Mounting holes
12. Kerf plate
13. Knob for mitre adjustment
14. Locking bolt for mitre adjustment
15. Scale for mitre angle
16. Indicator for mitre angle
17. Laser
18. Indicator for bevel angle
19. Scale for bevel angle
20. Workpiece clamp
21. Knob for bevel adjustment
22. Depth adjustment bolt
23. Dust bag
24. Carrying handle
25. Dust outlet
26. Rear tilt protector
27. Stop bolt for 45° bevel angle
28. Stop bolt for 0° bevel angle
29. Locking bolt for workpiece clamp
30. Hex key
31. Locking bolt for adjustable fence
32. Adjustment bolt for fence
33. Position lock knob
34. Screws
35. Retaining bolt
36. Clamping flange
37. Clamping bolt
38. Spindle lock
39. Knob for workpiece clamp
40. Knurled nut for depth adjustment
41. EN laser switch
42. Screws for laser adjustment
43. Lock nut for 45° bevel angle
44. Lock nut for 0° bevel angle
45. Fence bolts
3. ASSEMBLY
Before carrying out any work on the
machine, disconnect the mains plug from
the power supply.
Mounting the knob for mitre adjustment (Fig. A)
Mount the knob for mitre adjustment (13) by simply
screwing it clockwise in the thread.
Mounting the carrying handle (Fig. E)
1. Mount the handle on top of the machine, as
12
shown on Figure E.
2. Tighten the screws using a philips headed
screwdriver.
Transport position (Fig. B, C)
The position lock knob (33) makes it easier to move
the power tool when transporting it to various
working locations.
Unlocking the transport position (work position)
1. Press the handle (2) downwards slightly;
2. Pull the position lock knob (33) fully outwards
and lock it in place by turning it;
3. Slowly move the handle (2) upwards.
Locking the transport position (transport position)
Before locking in transport position, make sure
that the depth adjustment bolt (22) is adjusted to
unlimited depth. This way, the handle (2) can be
moved fully downwards without touching the depth
stop. Also, remove all accessories that cannot be
securely fitted to the machine.
1. Press the handle (2) fully downwards;
2. Lock the position lock knob (33) by first pulling
and then turning it;
3. Wind up the mains cable and tie it together with
the supplied cable strap.
After locking the transport position, use the carrying
handle (24) to safely carry and transport the machine.
Only use the carrying handle to transport the
machine and never the protective guards.
Install of a stationary machine (Fig. A, B, D)
To ensure safe handling, the power tool must be moun-
ted on a flat, stable work surface (e.g. work bench)
before use. You can install the machine in three ways:
1. On a workbench
In this case the machine must be secured to the
workbench using suitable screw fasteners. Use the
four holes (11) to do this. As shown on fig. D.
2. On a subframe
Read all the warnings and instructions
included with the saw stand. Failure to
observe the warnings and follow instructi-
ons may result in electric shock, fire and/or
serious injury.
WWW.VONROC.COM