Beko HTV 7732 XW0 Bedienungsanleitung Seite 36

2. Remove the nuts of the water intake
hoses to access the filters on the water
intake valves. Clean residues on them
with an appropriate brush. If the filters are
too dirty, remove them from their places
with a pliers and clean in this way.
3. Take out the filters on the flat ends of the
water intake hoses together with the gaskets
and clean thoroughly under running water.
4. Replace the gaskets and filters
carefully in their places and tighten
the hose nuts by hand.
6.5 Draining remaining water
and cleaning the pump filter
The filter system in your machine prevents
solid items such as buttons, coins and fabric
fibres clogging the pump impeller during
discharge of washing water. Thus, the water
will be drained without any problem and
the service life of the pump will extend.
If the machine fails to drain water, the pump filter
is clogged. Filter must be cleaned whenever it
is clogged or in every 3 months. Water must
be drained off first to clean the pump filter.
In addition, prior to transporting the machine
(e.g., when moving to another house)
and in case of freezing of the water, water
may have to be drained completely.
A
CAUTION!
• Foreign substances left in the pump
filter may damage your product
or may cause noise problem.
• If the product is not being used, shut the
tap, remove mains hose and drain the
water inside the machine in places where
there is the risk of the product freezing .
• After each use, turn off the water tap to
which the mains hose is connected.
1. In order to clean the dirty filter and
discharge the water, unplug the
machine to cut off the supply power.
A
CAUTION!
• Temperature of the water inside the
machine may rise up to 90 ºC. To avoid
the risk of burning, clean the filter after the
water inside the machine is cooled down.
36 / EN
2. Open the filter cover. Press the tab
in the direction of the arrow and pull
the cover out towards yourself.
3.To drain the water in the machine.
a. In order to collect the water to flow
out of the filter, place a large shallow
vessel in front of the filter.
b. Turn and loosen the pump filter until
water starts to flow (counterclockwise).
Fill the flowing water into the container
you have placed in front of the filter.
Always keep a piece of cloth handy
to absorb any spilled water.
c When the water inside the machine is finished,
take out the filter completely by turning it.
4. Clean any residues inside the filter as well
as fibres, if any, around the pump impeller
region.
5. Replace the filter.
6. Close the filter cover.
Washer-Dryer / User's Manual