Beko HTV 7732 XW0 Bedienungsanleitung Seite 32

C
INFORMATION
• The programme will not be cancelled
if you turn the programme selection
knob while child lock is enabled. You
should cancel the Child Lock first.
• If you want to open the loading door after
you have cancelled the programme but
you cannot do it since the water level in
the machine is above the loading door
baseline, turn the Programme Selection
knob to Pump+Spin programme and
discharge the water in the machine.
5.19 End of programme
Once the programme is completed,
the End symbol will be displayed.
If you do not press any button for 10 minutes,
the machine will switch to OFF mode.
Display and all indicators are turned off.
If you press any button, the completed
programme steps will be displayed.
5.20 Your machine has the
"Pause Mode" function.
After using the On/Off button to switch on the
machine, if you do not start any programme in
the selection step or do not perform anything
else, or if you do not do anything in 2 minutes
after the selected programme has ended, the
programme will automatically switch to energy
saving mode. Also, if your product has a display
that shows programme time, this display will be
completely turned off. If you turn the programme
knob or touch any button, the lights will switch
back to previous position. The selections you
make when exiting the energy efficiency mode
may change. Check if your selections are correct
before starting the programme. If necessary,
make adjustments again. This is not an error.
5.21 HomeWhiz and the
Remote Control Function
HomeWhiz allows you to use your smart device
to control your washing machine and get
information about it. Thanks to the HomeWhiz
application, you can use your smart device
to carry out some procedures you can also
do on the machine. Plus, you can use some
features only with the HomeWhiz function.
To use the Bluetooth function of your machine,
you should download the HomeWhiz app
from the application store of your device.
32 / EN
Make sure that your smart device is
connected to internet to download the app.
If you are using the app for the first time,
please follow the on-screen instructions
to complete the user registration process.
Once the registration is complete, you
can use all products with the HomeWhiz
feature in your house on this account.
On the HomeWhiz app, you can tap
"Add/Remove Appliance" to see the
products paired with your account. You
can pair these products on this page.
C
INFORMATION
• To be able to use the HomeWhiz function,
make sure that the app is installed on
your smart device and that your washing
machine is paired with your smart
device via Bluetooth. If the washing
machine is not paired with your smart
device, it will function as an appliance
without the HomeWhiz feature.
• Your product will run once it is paired with
your smart device via Bluetooth. Controls
made from the app will be enabled through
this pairing. For this reason, the Bluetooth
signal between the product and the
smart device must be strong enough.
• Please visit www.homewhiz.com to see
the Android and iOS versions supported
by the HomeWhiz application.
A
WARNING!
• All the safety measures described in
"GENERAL SAFETY INSTRUCTIONS"
section of your user manual apply
to remote control through the
HomeWhiz function as well.
5.21.1 HomeWhiz Setup
Your product and the HomeWhiz app
must be connected for the app to run. To
establish this connection, please follow
the steps below for setup both on your
product and on the HomeWhiz App.
• If you are adding an appliance for the first
time, tap "Add/Remove Appliance" on the
HomeWhiz App. Then tap "Tap here to
setup new appliance". Follow the steps
below as well as the instructions on the
HomeWhiz App to complete the setup.
Washer-Dryer / User's Manual