Herunterladen Inhalt Inhalt Diese Seite drucken

Electric Connections - Fantini Cosmi Intellitherm C68 series Installationshandbuch

Uhrenthermostat
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

1
WAL L MOU NT IN G
Install the programmable thermostat at
1,5 meters above the floor level, far from
kitchens, heat sources, windows and doors.
Make sure the base is fixed to a level surface,
without strains.
2
E LE CTR IC CO NN ECTIONS
Connect terminals 1 - 2 to the heating
system with two wires thus replacing the
traditional thermostat at any time and
without adding further connections. When
the ambient temperature increases, the
relay will open terminals 1 - 2 and will close
terminals 1-4.
Terminal 4 is free and it may be used for
signalling or other purposes, as required.
3
O F F M ODE SE LECTI ON
When in OFF mode, Intellitherm may be set
to keep a fixed temperature of 5°C to protect
the system from the risk of freezing.
This selection must be carried out during
the installation and before inserting the
batteries.
Note: if this selection is needed to be
changed after the installation, Intellitherm
has to be reset and reprogrammed.
4
M O U NTI NG T H E T HE RM OSTAT BODY
O N T H E B ASE
5
I N S E R TI NG AND R E PLAC ING THE
B AT T E R IE S
Insert two long life AA 1,5V alkaline batteries,
paying attention to the indicated polarity.
Batteries last approximately 2 years: when
they begin to run down, the battery symbol
starts to flash on the display. If the batteries
are not replaced within 15 days, Intellitherm
C68 will switch-off automatically and the
display will indicate OFF.
6
T I M E SE TT ING
( s e e t h e pi ct ure o n the right)
6
B 60 mm
A 83,5 mm
4 2
1
To insert batteries remove the cover pulling it frontaly
Intellitherm
I N S T A L L A T I O N
To separate the base from
the frontal body, remove the
battery cover and unscrew
the
screws,
thermostat body downwards.
A
for flush-mounting
boxes (3 modules, 503)
B
for round
flush-mounting boxes
To be installed
!
b y q u a l i f i e d
personnel only!
To set the ANTIFREEZE 5°C protection
move the dip switch HIGH.
To switch the system completely OFF,
move the dip switch DOWN.
-
+
-
1.5V
'AA'
'AA'
time setting keys
e n g l i s h
rotating
the
4
2
1
+
1.5V
A1 A2

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

Intellitherm c68cIntellitherm c68nC68-serieC68cC68n

Inhaltsverzeichnis