I Remote Control; Resetting The Factory Presets - Yamaha HTR-5730 Bedienungsanleitung

I Remote control

Problem
The remote control does
not work nor function
properly.

Resetting the factory presets

If you want to reset all of your unit's parameters for any
reason, do the following. This procedure completely
resets ALL parameters, including the SET MENU, level
and tuner presets.
Be sure this unit is in standby mode.
STANDBY/ON
STANDBY
/ON
PRESET/TUNING FM/AM A/B/C/D/E
EDIT NEXT
PHONES SPEAKERS STEREO PROGRAM
A/B/OFF
EFFECT
CONTROL BASS/TREBLE
SILENT CINEMA
STEREO
Cause
Wrong distance or angle.
Direct sunlight or lighting (from an
inverter type of fluorescent lamp, etc.) is
striking the remote control sensor of this
unit.
The batteries are weak.
VOLUME
RDS MODE/FREQ EON
PTY SEEK
MODE START
PRESET/TUNING MEMORY TUNING MODE
SET MENU MAN'L/AUTO FM AUTO/MAN'L MONO
INPUT
INPUT MODE 6CH INPUT
Remedy
The remote control will function within a
maximum range of 6 m (20 feet) and no more
than 30 degrees off-axis from the front panel.
Reposition this unit.
Replace all batteries.
1
Hold down STEREO on the front panel and
press STANDBY/ON.
"FACTORY PRESET" appears in the front panel
display.
y
To cancel the initialization procedure without making any
changes, press STANDBY/ON.
2
Press STEREO to select the desired setting.
Reset
To reset the unit to its factory presets.
Cancel To cancel without making any changes.
3
Press STANDBY/ON to confirm your
selection.
If you selected "Reset", the unit is reset to its factory
presets and switches to standby mode.
If you selected "Cancel", the unit switches to standby
mode and nothing is reset.
TROUBLESHOOTING
Refer to
page
7
–
3
51