Vimar Elvox TAB 40507 Kurzanleitung Seite 22

TAB: 40507
Configuration
Before the device is put into operation, it must be assigned a unique ID in the 2-wire bus system.
The configuration procedure starts by choosing whether the device is to be installed as a primary or secondary device; this choice depends
on the characteristics of the system.
The information displayed on the screen is as follows:
ID: unique number identifying the device. Prior to configuration the screen shows Not configured
Firmware: Version of the device's firmware
Mac: Media Access Control, this is the physical address used in a network to control access
Serial Number: The serial number of the device, assigned in the factory
Remember that the primary and secondary Configuration operations are subject to access control for security reasons. The user must therefore
enter the PIN before starting the procedure. Obviously the procedure will start only if the PIN entered matches that set.
The default PIN value is "0000"; to change the PIN see the chapter "Changing the PIN".
To assist the installer during the configuration operation and to enable communication with anyone at the entry panel, audio and video are
activated on the TAB 7S display.
Commands
starts configuration. On completion of the procedure, returns you to the settings screen;
quits without saving the changes made and returns you to the Settings page.
If the wrong PIN is entered this is immediately reported in the top bar of the virtual keypad, as shown in the following image.
EN
22