Description Of The Appliance; Operating The Appliance; Helpful Hints And Tips - Zanussi ZDK320 Benutzerinformation

Description of the appliance

Cooking surface layout
Electric cooking zones control knobs
Symbol
0

Operating the appliance

To switch on and increase the heat setting turn the knob
counterclockwise. To decrease the heat setting turn the
knob clockwise. To switch off turn the knob to the 0.
Power indicator is activated when either of the zones are
turned on, and will stay on until the cooking zones are
switched off.
Before first use
Set the maximum position and run the hob for 10 minutes,
to burn off any residues of manufacturing. After that run

Helpful hints and tips

Cookware
• The bottom of the cookware must be as thick and
flat as possible.
• Cookware made of enamelled steel and with aluminium
or copper bottoms can cause discoloration on glass
ceramic surface.
Energy saving
• If possible, always put the lids on the cookware.
• Put cookware on a cooking zone before you start
it.
12
1
180
mm
145 2
mm
3
4
Function
off position
1 Rear cooking zone 1700 W
2 Front cooking zone 1200 W
3 Power indicator
4 Control knobs
Symbol
1
6
hob at minimum position for 20 minutes. During this pe-
riod an odour and smoke can be emitted. This is normal.
Make sure the airflow is sufficient.
When a cooking zone operates, it hums for a short
time. This is typical of all ceramic glass cooking
zones and does not show that the appliance operates in-
correctly.
• Stop the cooking zones before the end of the cooking
time to use residual heat.
• The bottom of pans and cooking zones must have the
same dimension.
Use pots and pans with bottom applicable to the
dimension of burner.
Cooking area
Front
Rear
Function
minimum heat
maximum heat
Diameters of cookware
max. 145 mm
max. 180 mm