Cleaning And Maintenance; Technical Specifications - HQ Power VDL500SM Bedienungsanleitung

• Make sure there is no flammable material within a 50cm radius of the device.
• Have a qualified electrician carry out the electric connection.
• Connect the device to the mains with the power plug. Don't connect it to a dimming pack.
• The installation has to be approved by an expert before the device is taken into service.
6. Use
Connect the device to the mains and flick the power switch at the back of the device to ON. After the warm-up time
(approx. 5-8 minutes) the device is ready for use. The green indicator light is now lit:
• Activate/deactivate the smoke output with the push button.
• It may happen that the standby lamp on the remote control is off and the smoke emission stops, even while you
are holding the button. In this case the device is warming up again and will be ready to resume operation in a few
minutes' time. This process guarantees an appropriate vaporisation temperature and the best smoke emission
possible.

7. Cleaning and Maintenance

1. All screws should be tightened and free of corrosion.
2. Mechanically moving parts must not show any signs of wear and tear.
3. The electric power supply cables must not show any damage. Have a qualified technician maintain the device.
4. Disconnect the device from the mains prior to maintenance activities.
5. Wipe the device regularly with a moist, lint-free cloth. Do not use alcohol or solvents.
6. There are no user-serviceable parts, apart from the fuse (see "5. Installation" on p.2).
7. Contact your dealer for spare parts if necessary.
8. Clean the heating element after every 30 hours of use with a special cleaning liquid available from your dealer. Fill
the tank with the cleaning liquid and let the machine run for a while. When the device is cleaned, remove the
remaining cleaning liquid and rinse the tank thoroughly with distilled water. Never use regular water for cleaning or
rinsing!

8. Technical Specifications

Power supply
Power consumption
Fuse
Smoke output
Warm-up time
Tank capacity
Dimensions
Weight
Max. ambient temperature
Max. housing temperature
The information in this manual is subject to change without prior notice.
VDL500SM
max. 230VAC/50Hz
max. 500W
F 5A, 250VAC (5 x 20mm) (order code FF5N)
55m³/min
approx. 5-8 minutes
0.95 litres
280 x 170 x 140mm
2kg
45°C
130°C
3 VELLEMAN