Wireless Remote Control; Cleaning And Maintenance; Replacing The Fuse; General Troubleshooting - HQ Power HQSM10007 Bedienungsanleitung

•
A DMX terminator is recommended for installations where the DMX cable has to run a
long distance or is in an electrically noisy environment (e.g. discos). The terminator
prevents corruption of the digital control signal by electrical noise. The DMX terminator
is simply an XLR plug with a 120 Ω resistor between pins 2 and 3, which is then
plugged into the XLR output socket of the last device in the chain.
6.4

Wireless Remote Control

The included wireless remote control (Velleman
Assign each device to one push button of the wireless remote control. Each device will output fog/smoke
for as long as the respective button is being pressed.
7.

Cleaning and Maintenance

Before starting any cleaning or maintenance activities:
1. Unplug the device's power cord from the outlet.
2.
Let the device cool down.
Cleaning
•
Use normal glass cleaner and a soft cloth to wipe off the outside casing.
•
Always be sure to dry all parts completely before plugging the device back in.
•
Cleaning frequency depends on the environment in which the unit operates (i.e. smoke, fog residue,
dust, dew).
•
Do not immerse the device in any liquid.
Maintenance
•
All screws should be tightened and free of corrosion.
•
The housing, the lenses, the mounting supports and the installation location (e.g. ceiling, suspension,
trussing) should not be deformed, modified or tampered with; e.g. do not drill extra holes in
mounting supports, do not change the location of the connections...
•
Mechanically moving parts must not show any signs of wear and tear.
•
The electric power supply cables must not show any damage. Have a qualified technician maintain
the device.
•
There are no user-serviceable parts, apart from the fuse and the lamp.
•
Refer to an authorized dealer for service and/or spare parts.
7.2

Replacing the fuse

1. Unplug the device's power cord from the outlet.
2.
Let the device cool down.
3. Remove the rear cover with an appropriate screwdriver.
4. Open the fuse holder.
5. Replace with an identical fuse.
6.
Insert the fuse holder back in its place, replace the rear cover and reconnect power.
8.

General Troubleshooting

Symptom
No or erratic fog/smoke output.
V. 02 – 15/12/2016
HQSM10007
®
order code HQRC10001) can control up to 4 devices.
Possible Cause
Incorrect liquid.
Blocked pipe or failing part.
Incorrect power connection or
failing fuse.
Low or no liquid.
6
Possible Solution
Drain the liquid, clean
thoroughly and use the correct
liquid.
Contact your nearest dealer.
Check the power connection
and fuse.
Refill the tank with liquid.
©Velleman nv