Parts Identification; Warranty - DENTSPLY Essix Benutzerhandbuch

Vacuum thermoforming machine

Vorschau ausblenden

Inhalt

Inhaltsverzeichnis

Verfügbare Sprachen

Essix

MachinE UsEr ManUal

Thank you for your purchase of the The Essix

use. Operation of the machine is simple and you can learn correct operation in a matter of minutes.

The Essix

Machine utilizes an electrically driven vacuum motor to fabricate all types of dental appliances

more accurately than traditional vacuum forming machines. By incorporating a two stage motor, it produces

maximum adaptation, ease of use and professional results.

Please read the entire instruction manual before operating the Essix

operating procedures by carefully reviewing the following pages, however, mastering vacuum forming

techniques may require a longer period of time. Practice with appropriate materials is recommended. Also,

pay close attention to the Important Information statements included in each section.

sEtUp

The Essix

Machine requires minimal preparation for use. A few simple steps are necessary before operating

the unit:

1. HANdlES - Attach the two enclosed knobs into the threaded holes located at the rear of the hole plate.

2. PlACEMENT - The Essix

grounded standard electrical outlet.

CAUTION:

The unit should not be placed closer than 6" from walls, cabinets or other equipment while in

operation because of the temperature emitted from the heater. Do not place any items under the heater.

Under no circumstances should this unit be operated while located under or in a cabinet. Turn off the

machine when not in use. Do not store or operate any electrical appliance, like the Essix

near water.

3. ElECTrIC COrd - Plug the electric cord into a properly grounded electrical outlet.

ModEl prEparation GUidElinEs

STONE – Quality stone or gypsum that produces a hard, dense model is suggested. Softer materials may be

dusty. This dust may settle into the finished appliance.

BASE – The model should be as slim as practical – no more than ¾" from base to incisal edge. An excessive

base can result in thinning of the material and/or decreased details.

UNdErCUTS – The trimmed sides should be flat and cut at a 90° angle.

Undercuts and angles that cut into the base will create a vacuum lock and make it difficult to remove the

appliance. If possible, it is best to have the base flare out by a few degrees. This is completed during the

trimming stage.

STONE CHArACTErISTICS – The model should be dry.

Machine should be placed on an open level counter, within 4' of a properly

Machine. Please read the entire instruction manual before