Vitek VT-2520 BK Betriebsanweisung Seite 5

•
•
•
•
•
•
•
THE
HOUSEHOLD USAGE ONLY
USING THE HAIR CLIPPER
–
T-2520_100 x140.indd 5
Do not leave children unattend-
ed to prevent using the unit as
a toy.
Close supervision is necessary
when children under 8 years of age
or disabled persons are near the
operating unit.
This unit is not intended for usage
by children under 8 years of age.
Children aged 8 and over as well as
disabled persons can use this unit
only under supervision of a person
who is responsible for their safety
if they are given all the necessary
and understandable instructions
concerning the safe usage of the
unit and information about danger
that can be caused by its improper
usage.
Attention! Do not allow children
to play with polyethylene bags or
packaging film. Danger of suf-
focation!
Do not use the hair clipper if the
power cord or the plug is damaged
or if the unit works improperly.
Do not repair the unit by your-
self. Do not disassemble the unit
by yourself, if any malfunction is
detected or after it was dropped,
unplug the unit and apply to any
authorized service center from the
contact address list given in the
warranty book and on the website
www.vitek.ru.
UNIT IS INTENDED
After unit transportation or storage
at low temperature keep it for at
least three hours at room tempera-
ture before switching on.
–
Remove all stickers and packag-
ing elements that can prevent unit
operation.
Blades
–
If the blades have been removed
for cleaning or replacement, install
them back to their places and tight-
en the fastening screws. The unit's
design makes it unnecessary to
level the blades after installing them.
Lubricating oil
–
To maintain the hair clipper in a
good condition, you should lubri-
cate the blades regularly. Do not
use vegetable oil or oil that includes
solvents. Solvents are subjected
to evaporation, and the remaining
thick oil can slow down the upper
blade (4) moving speed.
–
For lubricating the blades use only
the oil (13), supplied with the unit.
Taper lever (2)
–
The taper lever (2), that moves
lower blade (3), is located under
the thumb (if you are right-handed).
When cutting hair you can move
the blade, pressing the lever (2),
thus adjusting the cutting length
without usage of the attachment
combs. In upper lever position,
haircut will be the shortest one.
FOR In down lever position the cutting
length is approximately the same as
with 3 mm attachment comb (6). By
changing the position of the lever
while cutting hair, you can select
the necessary cutting length.
5
ENGLISH
11.08.2016 10:11:59