Yamaha YAS-152 Bedienungsanleitung Seite 14

5
Make the sound bar learn the volume (+) operation.
5-1 Press VOLUME (+) on the front panel of the sound bar.
5-2 While pointing your TV remote control at the remote control sensor, hold
down the volume (+) key for more than 1 second twice or three times.
Result Bleep/buzzer
Successfully
Once
learned
Learning has
failed
Twice
* Repeat from
Step 5-1.
6
Make the sound bar learn the power operation.
6-1 Press (power) on the front panel of the sound bar.
6-2 While pointing your TV remote control at the remote control sensor, hold
down the power key for more than 1 second twice or three times.
Result Bleep/buzzer
Successfully
Once
learned
Learning has
failed
Twice
* Repeat from
Step 6-1.
7
To finish the learning mode, press the LEARN or
the supplied remote control.
This completes the necessary settings. Now you can operate the sound bar with
the TV remote control's power key or volume keys.
HINT
• The learning mode will be finished automatically if no operations are performed for 5 minutes.
• Set the TV volume to minimum. When you turn up the volume of the sound bar with the TV remote
control, the volume of the TV may be turned up at the same time. In this case, follow Step 3 in
"Connections" (p.5) to change the TV setting.
12
Indicators
Lights up
Flash
Indicators
Lights up
Flash
(power) key on
Clearing all learned operations
1
With the sound bar turned off, hold down the LEARN key on the
supplied remote control for more than 3 seconds. (for entering the
learning mode)
When the sound bar is in the learning mode, the indicators on the front panel flash
as shown below.
2
Hold down INPUT on the front panel of the sound bar for more than 3
seconds.
If the clearing is completed, you will hear the bleep sound three times.
3
Press the LEARN or (power) key on the supplied remote control.
Flashes in red (cleared)