Entering Centrifugation Parameters; Running Time; Time Selection; Continuous Running - Hettich ROTO SILENTA 630 RS Bedienungsanleitung

medirence.com
EN
13

Entering centrifugation parameters

It is only possible to enter a parameter when the input field is displayed inversely (dark background). An
inverse input field will go off automatically after 10 seconds.
13.1

Running time

13.1.1

Time selection

•
Press the key repeatedly until the parameter t/min: or t/ :sec is displayed. The input field will be displayed
t
inversely.
•
Set the desired value by means of the control knob
13.1.2

Continuous running

•
Select the parameters t/min: and t/ :sec one after the other (see Chapter "Time selection"), and set both to zero
using the control knob
13.2

Speed (RPM)

•
Press the key repeatedly until the parameter RPM is displayed and the input field is shown inversely.
n
•
Set the desired value by means of the control knob
13.3

Relative centrifugal force (RCF/RZB)

•
Press the
RCF
•
Set the desired value by means of the control knob
The centrifuging radius indicator will flash while the adjustment is being made.
13.4

Run-up and run-down parameters

The run-up and run-down parameters that have been set are displayed.
x: 1-9 = run-up step, t = run-up time
y
x
y: R1-R9, B1-B9 = braking step, R0 = unbraked run-down, t = run-down time, n
PROFIL
13.4.1

Run-up step

•
Press the
inversely.
•
Set the desired step by means of the control knob
13.4.2

Run-up time

•
Press the key repeatedly until the parameter
•
Set the desired value by means of the control knob
If a run-up time is set that is longer than the running time, the centrifugation run will end before the set speed is
reached.
13.4.3

Braking step

•
Press the
inversely.
•
Set the desired step by means of the control knob
B-braking steps can only be set for special rotors.
13.4.4

Run-down time

If a brake de-energisation speed has been set, it is not possible to set a run-down time.
•
Press the key repeatedly until the parameter
•
Set the desired value by means of the control knob
36/102
. "---:--" will be displayed in the input field.
key repeatedly until the parameter RCF/RZB is displayed and the input field is shown inversely.
energisation speed
key repeatedly until the parameter
key repeatedly until the parameter
.
.
.
or is displayed. The input field will be displayed
t
1-9
.
is displayed. The input field will be displayed inversely.
min:sec
t
.
or is displayed. The input field will be displayed
t
0-9
.
is displayed. The input field will be displayed inversely.
t
min:sec
.
(•)
= brake de-