Inhaltsverzeichnis
Werbung
Selection of function programme
GB
14
ATTENTION!
Adjustment of flushing programs only
possible in the first 10 s after initiation
(as soon as battery will be inserted or power
unit will be connected)
Program 1 factory-made pre-adjusted.
For changing the flushing program of an already
adjusted control, the power supply must be
disconnected for at least 60 s, afterwards a new
programming is possible.
Establish reflex with the hand (Hold hand 2 cm in
front of the sensor window)
Red LED flashes:
*
**
***
****
*****
******
******* Seventh = Prog. 7 - for small washbasins
Remove hand at the desired program (LED
1 x . . 2 x . . 3 x . .
flashes x times) - the control confirms the
program by flashing twice quickly.
Afterwards there are further 10 s for changing
the flushing program again. After lapse of this
time, the device flashes 3 times quickly and it
changes into normal function.
Once = Prog. 1 - without continuous
flow resp. continuous flow
Twice = Prog. 2 - Continuous flow
Third = Prog. 3 - Cleaning stop
Fourth = Prog. 4 - Continuous flow and
cleaning stop
Fifth = Prog. 5 - Continuous flow for
thermal disinfection, hygiene flush 3 h
Sixth = Prog. 6 - Continuous flow for
thermal disinfection, hygiene flush 24 h
Werbung
Inhaltsverzeichnis
