Oil Change; Air Filter; Spark Plug - Texas A/S 7600E Bedienungsanleitung

PROBLEM: The mower housing does not cut level.
1. Check the air pressure in the tires.
2. Adjust the level of the mower housing.
3. Check the front axle. If the front axle does not freely
pivot, loosen the axle bolt(s).
PROBLEM: The mower blades will not rotate.
1. Check the mower drive belt. Make sure the belt is
installed correctly.
2. Replace the mower drive belt.
PROBLEM: The unit will not move when the clutch is
engaged.
1. Check the motion drive belt. Make sure the belt is
installed correctly.
2. Adjust the clutch.
3. Replace the motion drive belt.
PROBLEM: The unit moves slower or stops when the
clutch is engaged.
1. Adjust the clutch.
2. Replace the motion drive belt.
PROBLEM: When the clutch/brake pedal is released,
belt noise can be heard.
1. Temporary belt noise does not change the operation
of the unit. If belt noise is continuous, check the
routing of the belt. Make sure the belt is inside all belt
guides.
2. If the noise is continuous, adjust the clutch.
PROBLEM: The rear wheels spin over uneven terrain.
1. Check the front axle. If the front axle does not freely
pivot, loosen the axle bolt(s).
PROBLEM: The transaxle is difficult to shift between
gears with the engine running and the clutch
depressed.
1. Check the clutch adjustment to make sure the belt
stops when the clutch pedal is depressed with the
transaxle in (N) neutral.
2. Check the belt guides around the transaxle drive
pulley. Make sure the belt guides do not touch the
pulley.

Oil change

Oil should be changed for the first time after 2 hours, then
at least 1 time per year.
You will need an oil extractor kit. Art. no. 40-11336
Oil and oil extractor kit is not included
Use an extractor kit and do as follows:
1. Turn on the engine and let it run for 5 min or until the
engine is hot. A hot engine liquefies the oil which
makes it easier to drain.
2. Suck the oil up through the oil filler hole using the
syringe that came with the oil extractor kit. Use the
hose to reach the sump.
3. Transfer the used oil into a empty container.
4. Fill the engine with SAE-30 oil (1.2 L).
5. Check the oil level using the dipstick. (Min / Max)
Remember to dispose the used oil so that it does no
harm to nature. Use your local recycling station.

Air filter

The air filter should be inspected and cleaned regularly. If
the filter has not been cleaned for a long time, the engine's
power will drop.
1. Clean around the air filter before removing the cap.
2. Unscrew the two nuts on of of cover and gently pull
the cover off.
3. Carefully remove the filter and inspect it. Brush the
inside paper filter it with a soft brush. If it is very dirty,
replace it.
Be careful that no dirt gets into the inlet.
4. Wash the black foam element in warm water and
soap.
5. Press the water out of the foam element and let it dry.
Put a few drops of SAE-30 oil on the filter to moisten it
lightly. Carefully squeeze any surplus oil out of the
foam element and reattach.
6. Please note that all parts are assembled correctly and
properly closed after installation.

Spark plug

1. Remove the spark plug.
2. Brush off dirt from the spark plug.
3. Use a spark plug wrench to loosen the spark plug.
4. Check the insulation is intact.
5. Clean the spark plug with a wire brush.
6. Measure the electrode, taking care not to damage the
electrode.
7. The distance should be: 0.7 to 0.8 mm
8. If the spark plug is undamaged refit or replace.
9. Reattach the spark plug.
34