Werbung
Verfügbare Sprachen
Verfügbare Sprachen
EN
1
A
A
A
2
2
A
A
3
A
A
B
B B
A
A
1
3
2
Technical instructions Pellet tank CPSP and feeder screw CPPT
8.
1
9.
1
10.
G
4
Connection of the inner part.
A - steel
sheet screw
1. lateral sides
2. inner part of the pellet tank
The inner part of the pellet tank has to be attached
with 3 screws in the profiles which are located on
the lateral side.
Connection of the back side of the
pellet tank.
A - steel
sheet screw
1. left lateral side
2. right lateral side
3. back side
Assemble the back side of the pellet tank on the
lateral sides with 6 screws 4.2 x 32 mm and with 3
screws 4.2 x 16 mm.
Assemble the front upper side.
G - nut M6
1. upper front side
2. rubber gasket
3. front part of the lid
4. back part of the lid
It is necessary to assemble the front upper side For
an ellipse in which we embed the feeder screw it is
necessary to mount the rubber gasket The second
ellipse, it is necessary to mount the elliptical cap.
Assemble the front part of the cover on the front side
in the elliptical opening, then assemble the
of the cover on the
screw nut.
Assemblage
3,9 x 9,5 mm
3,9 x 16 mm
.
back
side and tighten it with a
6x
6x
1x
.
back
part
17
Werbung
