Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Assemblage
4.0. ASSEMBLAGE
The order of assemblage of the pellet tank and the feeder screw is displayed on following
figures.
A
A
1
A
A
1
2
A
A
A
A
A
A
14
2
A
A
A
A
4
A
A
A
3
A
Technical instructions Pellet tank CPSP and feeder screw CPPT
1.
Connection of the inner sides of the
pellet tank.
A - steel
sheet screw 3,9x9,5mm
1.
front inner side
2.
left inner side
3.
right inner side
4.
back inner side
Connect the front inner side by screw with the left
and right inner side and then attach the back side.
The parts should be positioned in order the bigger
holes are placed at the inner side. The tightening of
the lateral sides to the front and back inner side is
to be done from inside to outside. The tightening of
the front side to the back side is to be done from
outside to inside, so that the bigger holes are
obligatory placed at the outer side.
2.
Tightening of the lids to the openings
for cleaning.
A - steel
sheet screw
1.
inner part of the tank
2.
lids of the front inner part
To the front inner side, from the outside, tighten
by means of screws the lids to the openings for
cleaning, according to the figure.
14x
3,9 x 9,5 mmm
EN
6x
Werbung
