ThermoFlux CPSP Technische Anleitung Seite 15

EN
A
1
A
A*
1
1
A*
1
Technical instructions Pellet tank CPSP and feeder screw CPPT
A
4
3
A
2
A*
4
3
2
A A
2
A A
A*
2
3. Connecting of the inside part of the
tank to the L-profiles.
A - steel sheet screw
1. front inner side
2. back inner side
3. L-profile of the inner side (longer)
4. L-profile of the back side (shorter)
L-profile are to be connected with screws to the
front and back inner side. The longer L-profile is to
be connected to the front inner side, while the
shorter L-profile to the back inner side. The
tightening is to be performed from outside to the
inside. The above figure shows the connecting of
the L-profile to the right type of the tank (marked
with lighter color) - screws marked *.
4. Connecting of the inside part of the
tank with the pellet router.
A - steel sheet screw
1. inside part of the tank
2. pellet router
The pellet router to be positioned to the L-profiles
and tightened to them by means of screws. The
above figure shows the connecting of the L-profile
to the right type of the tank (marked with lighter
color) - screws marked *.
Assemblage
3,9 x 9,5 mm
3,9 x 9,5 mm
6x
6x
15