ThermoFlux CPSP Technische Anleitung Seite 16

Assemblage
2
F
F
2
A A
A
A
2
A
A
1
A A A
2
16
1
perforated holes
for screws
1
1
1
A A
A
Technical instructions Pellet tank CPSP and feeder screw CPPT
5. Connection of the inner part of the
pellet tank with the porter of the
feeder screw.
F - screw M8x15 with the plastic head
1. inside part of the tank
2. porter of the feeder screw
Rip of the perforated steel sheet from the hole from
the side on which the feeder screw shall be
connected.
The porter of the feeder screw should be
positioned on the holes and tightened slightly but
not completely from the outside, in order to be able
to get through the feeder screw later.
6. Mounting hinges on the fundament
A - steel sheet screw
1. fundament
2. hinge
The door hinges have to be assembled on the
prepared holes on the tank fundament. If you want
the door opened from left to right hinge must be
mounted to right side of the prepared holes on the
fundament. If you want the door opened from right
to left hinge must be mounted to left side of the
prepared holes on the fundament.
Connection of the lateral sides of the
7.
pellet tank.
A - steel sheet screw
1. lateral sides
2. fundament
The left and the right lateral outer sides are to be
connected to the fundament by means of
mentioned screws.
3,9 x 16 mm
2x
3,9 x 9,5 mm
EN
2x
6x