Dismantling; Setting Up The Device; Connecting The Power Supply; Inserting Batteries - Silvercrest SKR 800 A1 Bedienungsanleitung

Dismantling

♦ Pull the device forwards off the mounting plate.
♦ Unscrew the screws (
from the wall cupboard.

Setting up the device

As an alternative you can stand the device on a level surface. To prevent the ventilation slots
and speaker
10
must be folded outwards:
♦ Reach into the recess on the side of the stand and pull it out as far as it will go.
♦ Select a suitable location for the device (see also the section Set-up location
requirements).

Connecting the power supply

CAUTION
► Before connecting the device compare the connection data (voltage and frequency)
on the rating plate with that of your electric supply. These data must agree so that
no damage is sustained by the device.
♦ Insert the power plug into a mains wall socket. The time (

Inserting batteries

By inserting 2 x 1.5 V batteries (type AA/Mignon/LR6) you can prevent the programmed
time or saved stations from being lost in the event of a power failure. The batteries make
sure that the internal clock continues to run even during a power outage. When power is
restored, the correct time automatically appears on the display.
NOTE
► The device can also be operated without a battery. The display, radio and alarm
do not function in emergency mode.
♦ Open the cover of the battery compartment
♦ Insert 2 x 1.5 V batteries (type AA/Mignon/LR6) (not supplied) into the battery
compartment. Insert the batteries as shown on the polarity diagram in the battery
compartment.
♦ Then close the battery compartment by replacing the cover and snapping it into place.

FM wire aerial

♦ Completely unwind the wire aerial
SKR 800 A1
or ) on the mounting plate and remove the mounting plate
15 16
on the bottom of the device from being covered, the device's stand
13
) flashes on the display
on the bottom of the device.
12
for FM radio reception.
GB
9
.
5
9