lidl HG03494A Bedienungs- Und Sicherheitshinweise Seite 8

of the product is damaged, it
has to be replaced by the manu-
facturer or its service department
or a similarly qualified person in
order to avoid hazards.
The product, including the tube,
does not contain any parts which
can be serviced by the user.
It is essential that the product
does not come into contact with
water or other liquids.
Never touch the mains plug with
damp or wet hands.
Protect the mains lead against
sharp edges, mechanical
stresses and hot surfaces.
CAUTION! ELECTRI-
CAL SHOCK!
Do not touch the high-voltage
grille while the product is in op-
eration. A small residual charge
still exists a few minutes after the
product has been switched off.
Never use the product in the
immediate vicinity of a bathtub,
shower or swimming pool.
Avoid the danger of
fire and injury!
Do not place the product on
inflammable surfaces.
Do not use the product in rooms
in which there is a danger of
8 GB/CY
fire, e.g. rooms in which flamma-
ble or explosive vapours or
dusts might be present (e.g. in
stables, barns or paint shops).
DANGER OF EXPLO-
SION!
As the product generates heat,
its use in the surroundings of all
highly inflammable or explosive
liquids or gases is prohibited.
For model HG03494B: the
product will continue to draw a
minimal amount of power when
switched off whilst plugged into
the socket. Unplug the mains
plug from the mains socket to
completely disconnect from
power.
Mounting on a wall
(for model HG03494B only)
Use the screws and dowels
8
mounting installation.
Measure up the wall or mounting surface for
drilling the holes. Use a spirit level to improve
accuracy.
Mark the two mounting holes
approx. 204 mm apart.
Now drill the mounting holes (ø approx. 7 mm,
depth approx. 36 mm).
CAUTION! Make sure that you do not dam-
age any electrical cables during this operation.
Insert the dowels into the drilled holes.
9
Insert the screws into the dowels
8
tighten them.
Attach the product to the secured screws
for wall
9
a distance of
7
and
9
.
8