Operation - Velleman MONSB1 Handbuch

Connections
The monitor incorporates video loop-through connectors & a switchable 75Ω-terminator. The device can therefore be
used individually or in combination with up to two other monitors for the display of a common video signal.
USE WITH ONE SINGLE MONITOR
CCTV CAMERA
1 = sub-brightness
2 = focus
3 = V-size
4 = V-linear
CCTV CAMERA
From video output
75Ω-terminator
in "Hi"-position

6. Operation

1. Install the monitor as outlined in "5.Installation". Make sure that the termination switch is in the "75Ω"-position
and that a standard 1.0 Vp-p video signal is applied to the monitor's VIDEO INPUT.
2. Press the power switch to activate the monitor. The power LED should light up.
3. Adjust the brightness and contrast controls to obtain optimum picture quality.
4. A bright and clear picture should now be displayed. In case of poor picture quality, the user should verify whether
the camera (or another video source e.g. VCR, video switcher) has been set with precision.
MONSB1
5 = video input & output
6 = 75Ω-terminator
7 = audio input
8 = AC power cord
To video input
75Ω-terminator
in "Hi"-position
USE WITH MULTIPLE MONITORS
From video output
75Ω-terminator
in "75Ω"-position
3
To video input
VELLEMAN